Driver’s Course Layout and Discussion Points
Course Layout:
- The above illustration represents the entire driver course as it is to be laid out and performed.
- The 3 down / 4 across cone set-up can be modified to 2 down / 3 across to accommodate space restrictions.
- The Trainer will demonstrate the entire process, including inspections and course performance. (Not a student)
Trainer Locations and Instructions:
- The letters A (START/FINISH) and B (COURSE) as illustrated on the map indicate Trainer Locations.
- Trainer at Location A will work with the Driver being tested covering:
- Truck and Course Inspection
- Course Layout START
- Layout assuring proper stopping at FINISH cone with truck’s rear against cone
- Trainer at Location A will work with the Drivers and observing Trainees:
- Continual observation of current driver
- Asking observers what is done well
- Soliciting improvements from observers that could be ade by driver
- Providing specific instruction, feedback and tips to observers and driver on how to operate PIT and driving techniques
- Trainer at Position B will work with the Drivers:
- Providing specific instruction for driving the course
- Providing specific instruction, feedback and tips to driver on how to operate PIT and driving techniques
- Trainer at Location A will work with the Driver being tested covering:
- On average each driver will take approximately 15 minutes to complete the course in its entirety
- If an individual fails any task on Appendix A it is recommended that they redo the task(s) after all drivers have completed the training until they are successful in its completion
If an individual fails the driver portion (less than 70% success) it is required that they retake the entire driving portion until completed 100% successfully.